PDA

View Full Version : Urgent can any1 help Technics 1210



KennedY
Dec 5th, 2009, 23:18
Pls help been on my decks tonight and now 1 deck keeps speeding up and slowing down. Frustrating to say the least lol any1 have any clues?????:sleeping::sleeping:

KennedY
Dec 5th, 2009, 23:22
well gutted too as im a bit spanked lol....Spannered

Lazarus
Dec 6th, 2009, 11:36
If it's a slight deviation I'd expect it might be something near to it that it a source of magnetism that's interfering with the pitch control, if it's speeding up and slowing a lot though then I've no idea :smile:

Resonate
Dec 6th, 2009, 13:07
Is this happening when you touch the pitch control? If so your slider/resistor is screwed. Its a reasonably simple job to do but does require soldering, parts should cost a few pounds.

You can get away with it for a bit maybe by putting some WD40 oil on it and working it in by moving the slider, much like you would with a buggered fader or x fader on a mixer. Dont put too much WD40 just a little.

evyqueen87
Dec 7th, 2009, 19:55
take out the plate and clean the dust on the edge of the plate or inside the rim...i do leave my covers off and it tends to happen ...hope it can help ...also the little pole in the middle may need some oil ..i put a little oil on the pole...lubricate carefully and clean excess oil ...good luck :hug:

KennedY
Dec 16th, 2009, 14:19
Thanks guys will try all the above at work at the min, shall try later thanks again.......Fingers crossed lol :bravo: